SKF 40PGA - Commissioning and Daily Start-Up; Cleaning

- 12 -
16642
Version 02
EN
1. Safety instructions
EN
1. Safety instructions
○ Lubricant lines should be primed with
lubricant prior to installation. This ma-
kes it easier to bleed the system of air
afterwards.
○ Observe the specified tightening torques.
Use a calibrated torque wrench.
○ When working with heavy parts, use sui-
table lifting tools.
○ Avoid mixing up dismantled parts or
assembling parts in the wrong order by
marking the parts accordingly.
1.17 Commissioning and daily start-up
Ensure that:
○ All safety devices are completely installed
and work properly.
○ All connections are correctly connected.
○ All parts have been correctly installed.
○ All warning labels on the machine are
complete, highly visible and undamaged.
○ Replace illegible or missing warning
labels without delay.
1.18 Cleaning
○ There is a risk of fire and explosion when
using flammable cleaning agents. Use
only non-flammable cleaning agents sui-
table for the purpose.
○ Do not use aggressive cleaning agents.
○ Do not clean using a steam jet or pres-
sure washer, as these may damage
electrical components. Observe the IP
protection class.
○ Cleaning work on energised components
may be carried out by electrical specia-
lists only.
○ Mark damp areas accordingly.