- 13 -
16642
Version 02
EN
1. Safety instructions
EN
1. Safety instructions
1.19 Residual risks
Residual risk
Possible in life-
cycle stage
Prevention / remedy
Personal injury / material damage due to
falling of raised parts
A, B, C, G, H, K
Keep unauthorised people away. Make sure no one remains under suspended parts or loads.
Lift parts with suitable and tested lifting devices.
Personal injury / material damage due to
tilting or falling of the product because of
non-observance of the stated tightening
torques
B, C, D, G
Observe the specified tightening torques. Fasten the product to components with adequate
load-bearing capacities only. If no tightening torques are stated, apply tightening torques ac-
cording to the screw size characteristics for 8.8 screws.
Personal injury / material damage due to
electric shock from a damaged connec-
tion cable
B, C, D, E, F,
G, H
Check that the connection cable is intact before using it for the first time and, after that, at
regular intervals. Do not mount the cable to moving parts or at a friction point. If this cannot be
avoided, use either spring coils or protective conduits depending on the circumstances.
Personal injury / damage to material due
to spilled or leaked lubricant
B, C, D, F, G,
H, K
Be careful when filling the reservoir and connecting or disconnecting lubricant feed lines.
Always use suitable hydraulic screw connections and lubrication lines suitable for use in the
stated pressures. Do not mount lubrication lines to moving parts or friction points. If this can-
not be avoided, use either flexible hose lines, spring coils or protective conduits depending on
the circumstances.
Lifecycle stages: A = transport, B = installation, C = commissioning, D = operation, E = cleaning, F = maintenance, G = fault, repair,
H = decommissioning, K = disposal
To Next Page
Loading...
Need help?
General
