- 9 -
16642
Version 02
EN
1. Safety instructions
EN
1. Safety instructions
1.4 Forseeable misuse
Any use differing from that stated in these
instructions is strictly prohibited, particularly
the following:
○ Use outside the indicated temperature
range
○ Use of non-specified lubricants
○ Use without adequate pressure relief
valve
○ Use in continuous operation
○ Use in areas with aggressive or corrosive
materials (e.g. high ozone pollution)
○ Use in areas with harmful radiation (e. g.
ionising radiation)
○ Feeding, forwarding, or storing hazard-
ous substances and mixtures described
in annex I part 2-5 of the CLP regulation
(EG 1272/2008)
○ Feeding, forwarding or storing gases,
liquefied gases, dissolved gases, va-
pours or fluids whose vapour pressure
exceeds normal atmospheric pressure
(1013 mbar) by more than 0.5 bar at
the maximum permissible operating
temperature
○ Use in an explosion protection zone
1.5 Painting of plastic parts prohibited
Painting of any plastic parts or seals of the
described products is expressly prohibited.
Remove or completely tape the relevant
parts before painting the machine in which
the product is installed.
1.6
Unauthorized modifications to the product
Unauthorised conversions or modifications
may result in unintended effects on product
safety and functionality. Therefore, any un-
authorised conversions or modifications are
expressly prohibited.
1.7 Prohibition of certain activities
Due to potential sources of faults that may
not be visible, or due to legal regulations, the
following activities may be carried out only
by the manufacturer’s specialists or persons
authorised by the manufacturer:
○ Opening the lubricant reservoir
○ Safety valve adjustment, repair or re-
moval
1.8 Compliance with other applicable
documents
In addition to these instructions, the fol-
lowing documents must be observed by the
respective target group:
○ Operational instructions and approval
rules
○ Safety data sheet (SDS) of the lubricant
used
○ Project planning documents
○ Instructions provided by the suppliers of
purchased parts
○ Any documents of other components
required to set up the centralised lubrica-
tion system
○ Other documents relevant for the inte-
gration of the product into the machine
or system.
To Next Page
Loading...
Need help?
General
