- 35 -
16642
Version 02
EN
11. Delivery, returns and storage
EN
11. Delivery, returns and storage
11. Delivery, returns and storage
11.1 Delivery
After receipt of the shipment, check the
shipment for transport damage and com-
pleteness by comparing it to the shipping
documents. Immediately report any dam-
age suffered in transport to the forwarding
agent.
Keep the packaging material until any dis-
crepancies are resolved. During in-house
transport, ensure safe handling.
11.2 Returns
Clean all parts and pack them properly (i.e.
following the regulations of the recipient
country) before returning them.
Protect the product against mechanical
stress (knocks, impacts). Land, sea or air
transport can be used for returns.
Mark returns on the packaging as follows.
11.3 Storage
SKF products are subject to the following
storage conditions:
○ Store in a closed, dry, dust- and vibrati-
on-free place.
○ Make sure there are no corrosive, ag-
gressive materials at the place of storage
(e. g. UV rays, ozone).
○ Protect against pests and animals
(insects, rodents, etc.).
○ Can be stored in original product
packaging.
○ Shield the product against heat and cold.
○ in case of high temperature fluctuations
or high humidity, take adequate measu-
res (e. g. heater) to prevent condensation.
○ The product’s acceptable storage tempe-
rature range is the same as its operating
temperature (see Technical data).
Before using the products, in-
spect them for damage sustained
in storage. This applies to parts
made of plastic and rubber
(embrittlement) as well as com-
ponents primed with lubricant
(ageing) in particular.
To Next Page
Loading...
