To Next Page

To Previous Page

- 23 -

16642

Version 02

7. Installation

7.1 General information

Only qualified technical personnel may install

the products described in these Instructions.

During installation, pay attention to the

following:

○ Be careful not to damage other devices

during installation.

○ The product must not be installed within

the range of moving parts.

○ The product must be installed at an ade-

quate distance from sources of heat and

cold.

○ Observe the product's IP protection class

when selecting the installation position.

○ Make sure that MIN/MAX reservoir mar-

kings, the low level switch indicator and

other visual indicators are fully visible.

○ Observe the prescriptions concerning the

installation position in chapter 5: Techni-

cal data.

7.2 Installation position

Protect the product against humidity, dust

and vibrations and install it in an easily

accessible position to ensure all other instal-

Figure 5

lation work can be carried out without any

problem.

Installation details and tightening torques for 40PGAS and 40PGAP

Max. 10 Nm

±90°

O 7

SKF 40PGA User Manual

Other manuals for SKF 40PGA