- 36 -
16642
Version 02
EN
12. Cleaning
EN
12. Cleaning
12. Cleaning
12.1 Cleaning agents
Use only cleaning agents compatible with
the material. For further information, see
Chapter 2.3: Material compatibility.
Thoroughly remove cleaning
agent residues from the product
and rinse with clear water.
CAUTION
Conduct cleaning only on depressurised products that have been disconnected from the power supply. Do not touch cables or electrical
components with wet or damp hands.
Use steam-jet cleaners or pressure washers only in accordance with the IP protection class of the pump. Otherwise electrical components
may be damaged.
Follow the operator’s standard operating procedures and instructions concerning cleaning, cleaning agents, suitable tools and personal pro-
tective equipment.
12.2 Exterior cleaning
• Mark and secure wet areas.
• Keep unauthorized persons away.
• Clean all outer surfaces thoroughly with a
damp cloth.
12.3 Interior cleaning
Interior cleaning is not usually required.
However, if incorrect or contaminated lu-
bricant has been used, the product must be
cleaned on the inside.
To do so, contact the SKF Customer Service
for further instructions.
To Next Page
Loading...
