INTEGRATION WITH SKF @PTITUDE OBSERVER
Hierarchy view – adding sensors and measurements
SKF Enlight Collect IMx-1 System
User Manual
Revision F
On the lower part of the main tab is the possibility to add an associated
measurement. This can only be a software speed point used to associate a machine
speed with the data.
The four measurements each have their own sub-tab in the sensor configuration
dialog:
Sub-tabs for each measurement type typically have three zones where aspects of
that measurement can be configured or are available for review:
General: an area to report the measurement name, engineering units and
detection.
Acquisition: for the vibration measurements to configure the number of
lines, select “No. of lines” from the dropdown. Available value is either 400,
800, 1600 or 3200 lines.
To change the "Frequency range" select from the dropdown:
• 10 Hz - 10 kHz, 600 - 600 000 cpm
• 10 Hz - 5 kHz, 600 - 300 000 cpm
• 10 Hz - 2 kHz, 600 - 120 000 cpm
• 10 Hz - 1 kHz, 600 - 60 000 cpm
Alarms: for all measurements an area to configure, set or disable alarms
associated with each. Note that low warning and low alarm are available only
for temperature measurements. All alarms are disabled by default, with
thresholds set to zero.
To Next Page
Loading...
