Ski-Doo Expedition LE - How to Read Fault Codes

MONITORING SYSTEM
PILOT
LAMP(S)
ON
BEEPER
MESSAGE
DISPLAY
DESCRIPTION
—
4short
beeps
every
5
minutes
REV LIMIT
Engine RPM limited for protection w h en
certain faults occur.
——
OVER REV
On E-TEC engines, indicates that maximum
engine RPM is reached. Check clutch
calibration.
—
Short
beeps
repeating
rapidly
SHUTDOWN
Shutdown procedure in force due to engine
overheating or fuel pump problem, remove
tether cord cap from engine cut-off switch
and contact an authorized Ski-Doo dealer.
——
COMMUNICATION
Communication problem betwee n ECM
and gauge. S top engine, remove tether
cord cap . Wait a few minutes, then start
engine. If probl em persists, con tact an
authorized Ski-Doo dealer.
2short
beeps
—
Good key, vehicle ready to operate.
2short
beeps,
repeating
slowly
CHECK KEY
Unable to read key (bad connection). Make
sure the key is clean and correctly snapped
on post.
D.E.S.S.
Short
beeps
repeating
rapidly
BAD KEY
Invalid key or key not programmed . Use
the proper key fo r the vehicle o r have the
programmed.
——
(blinking)
Fuel level sensor problem.
——
THROTTLE OPEN
Throttle lever applie d while attempting an
engine start (engine cranks but won't run).
Release throttle while starting.
——
DROWN MOD E
Throttle lever wide open while atte mpting
an engi ne start (engine cranks but w on 't
run). Release throttle while starting.
How to Read Fault Codes
Multifunction Analog/Digital
Display Only
To read any active fault code, press
andholdMODE(M)Buttonandsimul-
taneously depress the HI/LOW beam
switch repeatedly several times.
If two or more codes are registered,
use SET (S) or MODE (M) to scroll.
To exit the fa ult co de s m ode, press and
hold M ODE (M) Button.
Contact an authorized S ki- Doo dealer
for code signification.
134
______________