OPERATING MODES (900 ACE ONLY)
Learning Key Modes
The learning key provides a mode of
operation whereby engine torque and
speed are limited .
NOTE: The initial learning key pro-
gramming can limit the speed
to 40 km/h (25 MPH) o r 70 km/ h
(43 MPH). Refer to your authorized
Ski-Doo deale r to modify this setting.
There a re 3 levels available f or the
learning key mode.
Changing Learning Key Settings
To change learning key setting, carry
out the following:
1. Press the START/electronic reverse
button to wake up the electrical sys-
tem and install the NORMAL key on
theenginecut-offswitch.
2. Wait for the info rmation center to
complete its self-test and display
the key recognition message.
Analog/Digital Gauge
3. P r ess t he SET button until LEArn is
visible in the digital screen of the in-
formation center.
Multifunction A nalog/Digital Gauge
4. Press the MODE button once, then
press th e SE T button until LE ARN
is visible in the digital center of the
gauge.
mmo2014-004-001_f
MULTIFUNCTION GAUG E
1. MODE function
2. SET function
All Models
5. Use the heated grip switch to toggle
the key setting between 1 and 3.
mmo2014-004-002_a
TYPICAL
1. H eated grip switch
2. Increase
3. Decrease
NOTE: Se ttin g 1 is the lowest avail-
able to rque, while setting 3 is th e high-
est available torque for learning key.
6. After a few seconds, the setting is
automatically confirmed and saved.
NOTE: The key speed setting is appli-
cable to any key of the same type used
on a specific snowmobile. The same
key type used on a different snowmo-
bile may therefore have a different key
speed setting.
NOTE: Vehicle perform ance may vary
depending on riding conditions.
_______________
73
To Next Page
Loading...
