Ski-Doo Expedition LE - Break-In Period; Operation During Break-In

BREAK-IN PERIOD
Operation During Break-In
A break-in period of 10 operating ho u rs
or 500 km (300 mi) is required for the
vehicle.
After the break-in period, the vehicle
should be inspected by an authorized
Ski-Doo d ea ler. Refer to
MAINTE-
NANCE
section.
Engine
During the break-in period:
– Avoid prolonged full throttle opera-
tion.
– Avoid sustained accelerations .
– Avoid prolonged cruising speeds.
– Avoid engine ov erheating.
However, brief accelerations and
speed variations contribute to a good
break-in.
During the first few hours of break-in,
the engine m anagement system con-
trols som e e ngine parame t ers w hich
will slightly reduce the engine perfor-
mance.
E-TEC Mode ls
During a predetermined period, the
engine management system controls
some engine parameters.
The duration is based on fuel volume.
It will take approximately two fuel
tanks to complete the break-in.
During this period:
– The engine performance and behav-
ior will not be optimal.
– The fuel and oil consumption will be
higher.
Drive Belt
A new drive belt requires a break in pe-
riod of 50 km (30 mi).
During the break-in period:
– Avoid strong acceleration and decel-
eration.
– Avoid pulling a load .
– Avoid high spee d cruising.
_______________
71