MAINTENANCE PROCEDURES
This subsection includes instructions
for basic maintenance procedures. If
you have the n ec es sary mechanical
skills and the required tools, you can
perform these procedures. If not, see
your authorized Ski-Doo dealer.
Other important items in the mainte-
nance schedule that are m ore difficult
and require special tools are best per-
formed by your authorized Ski-Doo
dealer.
WARNING
Turn off the engine, remove tether
cord c ap and follow these ma in te-
nance p ro ce du res when pe r fo rm-
ing maintenance. If you do not
follow proper maintenance pro-
cedures you can be injured by hot
parts, moving parts, electricity,
chemicals or other hazards.
WARNING
Should removal of a locking device
be required (e.g. lock tabs, self-
lockin g fasteners, etc. ) when un-
dergoing disassembly/assembly,
always replace with a new one.
Air Intake Silencer
Prefilter
Air Intake Silencer Prefilter
Verification
Ensure that air intake silencer prefilter
is properly installed, clean and in good
condition.
mmo2009-004-032_a
1. Prefilter
To remove prefilter, simply pull it out.
To install prefilter, push it back in plac e
making sure it is properly secured.
Engine Coolant
WARNING
Never open coolant tank cap when
engine is hot.
Engine Coolant level
Remove the upper RH side panel. Re-
fer to
SIDE PANELS
in
CONTROLS,
INSTRUMENTS AND EQUIPMENT
subsection.
The cold level line is just above the re-
taining clamp.
mmo2009-004-028_b
TYPICAL
1. Cold level line
94
______________
To Next Page