EasyManua.ls Logo

Ski-Doo Expedition LE - Gearbox Operation; Shutting off the Engine; Towing an Accessory

Ski-Doo Expedition LE
163 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATING INSTRUCTIONS
WARNING
Make sure tether cord cap is re-
moved before standing in front the
vehicle, getting close to the track
or rear suspension components.
NOTE: On E-TEC models, warm-up is
electronically controlled. During this
period (up to 10 minutes depending on
ambient temperature), engine RPM is
limited.
Gearbox Operation
NOTICE
– Always put gearbox in 1
st
gear
whe n pulling a load.
– Always put gearbox in neutral (N)
when parked.
– Com e to a complete stop and hold
brake before shifting to or from
reverse. Wait until the reverse
alarm sounds before operating
throttle.
Neutral
When set in neutral (N), the gearbox
disengages the pulleys from the track.
Shifting in Reverse
To engage reverse gear, proceed as fol-
lows:
1. Bring vehicle to a com plete stop.
2. Apply a nd hold brake.
3. With engine at idle speed, select
reverse (R) gear using th e ge ars hift
lever.
NOTE: It is necessary to push s hift
lever knob down to move it from neu-
tral to reverse gear.
4. Gently depress throttle lever.
WARNING
The reverse speed is not limited.
Always proceed with caution as
fast reverse could result in loss of
vehicle stability. Always remain
seated. Ensure the path behind is
clear of obstacles or bystanders
before proceeding.
Shifting in Forward
There are two forward gears.
To engage a forward gear, proceed as
follows:
1. Bring vehicle to a com plete stop.
2. Apply a nd hold brake.
3. With engine at idle speed, select
low (1) or high (2) gear using the
gearshift lever.
4. Gently depress throttle lever.
NOTE: Do not shift wh en vehicle is
moving.
Shutting Off the Engine
Release throttle lever and wait until en-
gine has returned to idle speed.
Shut off the engine using either the
emergency engine stop switch or by
pulling off the tether cord ca p from th e
engine cut-off switch.
WARNING
Always remo ve the teth er cord cap
from engine cut-off switch when
vehicle is not in operation in order
to prevent accidental engine start-
ing or to avoid unauthorized use
bychildrenorothersortheft.
Towing an Accessory
Always use a rigid tow bar to tow an ac
-
cessory. Any towed accessory should
have reflectorsonbothsidesandat the
rear. Check local laws for brake l
ight(s)
requirements.
76
______________

Table of Contents