Ski-Doo Expedition LE - Injection Oil (600 HO E-TEC); Engine Oil (1200 4-TEC; 900 ACE)

MAINTENANCE PROCEDURES
Check coolant level at room temper-
ature with the cap removed. Liquid
shouldbe at coldlevel line(enginecold)
of coolant tank.
NOTE: W h en checking coolant level at
low tem perature it ma y be slig htly be-
low t he cold level line.
To add coolant, remove front coolant
tank fixation and slightly pull the tank
outwards to make room for the cap.
If additional a large amount of coolant
has to be added or if entire system has
to be refilled, refer to an authorized
Ski-Doo dealer.
Recommended Engine Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specifi-
cally for internal combustion aluminum
engines.
Cooling system mus t be filled with
BRP PREMIXED COOLANT (P/N 219
700 36 2) o r with distilled water and an-
tifreeze solution (50% distilled wa ter,
50% antifreeze).
Injection Oil
(600 HO E-TEC)
Addi ng Inje ction Oi l
Remove the upper RH side panel. Re-
fer to
SIDE PANELS in CONTROLS,
INSTRUMENTS AND EQUIPMENT
subsection.
Always maintain a sufficient amount of
recomm ended inje ctio n oil in the injec -
tion oil reservoir.
mmo2009-004-028_a
TYPICAL
1. Oil reservoir
Unscrew injection oil reservoir cap to
fill up reservoir then fully tighten.
NOTE: Do no t overfill. Do not pa ss
the MAX range in the reservoir filler
neck.
NOTICE
Check level and refill ev-
erytimeyourefuel.
WARNING
Do not overfill. Reinstall cap and
fullytighten. Wipeoffanyoil
spills. Oil is high ly flamm able
when heate d.
Engine Oil
(1200 4-TEC / 900 ACE)
Recommended Engine Oil
ENGINE
RECOMMENDED
ENGINE OIL
1200 4-TEC
900 ACE
XPS 4-STROKE
SYNTHETIC OIL
(ALL CLIM ATE )
(P/N 293 600 112)
_______________
95