OPERATING INSTRUCTIONS
mmo2008-005-009
4. Hook up clip on drive pulle y.
mmo2008-005-012_a
1. Clip installation location
5. Wind the rope tightly around drive
pulley. When pulled, pulley must
rotate counterclockwise.
mmo2008-005-014_a
6. Pull the rope using a sharp, crisp pull
so the rope comes free of the drive
pulley.
WARNING
When starting the snowmobile
in an emergency s ituation, using
drive pulley, do not reinstall the
belt guard and return slowly to
have snowmobile repaired.
Vehicle Warm-Up
Before every ride, vehicle has to be
warm ed up as follows:
1. Start e n gin e as explained in
ENGINE
STARTING PROCEDURE
above.
2. Allow engine to warm up one or two
minutes at idle speed.
NOTE: It is not recommended to let
engine running at idle speed for m ore
than 10 m inutes.
3. Disengage parking brake.
4. Apply throttle until drive pulley en-
gages. Drive at low speed the first
two or three minutes.
NOTICE
If vehicle does not move
whe n throttle is applied, stop en-
gine, remove tether cord cap from
the engine cut-off switch, then do
the following.
– Check if skis are stuck on the
ground. Lift one ski at a time by
the handle, then put it down.
– Check if track is stuck on the
ground. Lift rear of snowmobile
enough to clear track from the
ground, then drop.
– Check rear suspension for hard
snow or ice accumulation that
could interfere with track rota-
tion. Clean the area.
CAUTION Use proper lif ting
techniques, notably using your legs
force. Do not attempt to lift the rear
of vehicle if it is above yo ur limits.
_______________
75
To Next Page
Loading...
