CONTROLS, INSTRUMENTS AND EQUIPMENT
gine thereafter. This engine stopping
procedure will become a reflex and will
prepare operators for emergency situ-
ations requiring its use.
WARNING
If the switch has been used in an
emergency caused by a suspected
malfunction, the source of the mal-
function should be determined
and corrected before restarting
engine. See an authorized Ski-Doo
dealer for servicing.
8) Multifunction Switch
Multifun ction sw itch is locate d on the
LH side of handlebar.
mmo2014-004-001_c
TYPICAL
1. Start button
2. Headlights dimmer switch
3. Heated grips
4. Heated thro ttle lever
5. Mode/set button
Start Button
Presstostartengine. Referto
ENGINE
STARTING PROCEDURE
in the
OPER-
ATING INSTRUCTIONS
subsection.
Headlights Dimmer Switch
Press to select HI or LOW beam.
Lights are automatically ON when the
engine is running.
Heated Grips and Throttle Lever
Switch
E-TECModels
NOTE: Under 1900 RPM, heated grips
or throttle lever will be limited at 50 %.
All Models
Depress switch as required to select
heating intensity to keep your hands at
a comfortable temperature.
Heated Grips Switch
mmo2014-004-002_a
TYPICAL
1. H eated grip switch
2. Increase heat
3. Decrease heat
The heating intensity is displayed via
the multifunction display.
mmo2007-009-043_b
HEATING INTENSITY DISPLAY
1. Less heat
2. More heat
_______________
41
To Next Page