Engine fault
or illuminates
›
Stop driving!
›
Stop the engine and seek the help of a specialist
garage.
Disconnecting, connecting and replacing
CAUTION
Risk of re!
▶
Do not mix up the connection cables.
Disconnecting
›
Close the electric boot lid, all windows and the
electric sunblind.
›
Switch o the ignition and any connected power
consumers.
›
Disconnect the
terminal and then the termi-
nal.
Connecting
›
Connect the
terminal and then the terminal.
After switching on the ignition, the indicator lights
light up from the isolation box.
›
If, after a short distance, one of the above-men-
tioned indicator lights does not go out, seek the
help of a specialist garage.
Operate these vehicle functions after disconnect-
ing and connecting the 12 volt vehicle battery
▶
Clock setting » page 56.
▶
Window operation » page 28.
▶
Sunblind » page 29.
Changing
The new 12 volt vehicle battery must have the same
parameters as the original battery. Have the replace-
ment carried out by a specialist garage.
Using the jump-starting cable
Usage
With the help of jump start cables, a vehicle with a
discharged or defective 12-volt vehicle battery can
be started using the 12-volt vehicle battery of an-
other vehicle.
What you should be mindful of
WARNING
Risk of explosion and chemical burns!
▶
Do not jump start with the 12 volt vehicle battery
of another vehicle under the following conditions:
▶
The discharged 12 volt vehicle battery is fro-
zen. A discharged 12 volt vehicle battery may
already freeze at temperatures just below 0 °C.
▶
The acid level of the 12-volt vehicle battery is
too low » page 158.
Use jump leads with a sucient cross section and in-
sulated terminal clamps.
The rated voltage of both batteries must be 12V. The
capacity (in Ah) of the 12 volt charging vehicle bat-
tery must not be signicantly lower than the capaci-
ty of the discharged 12 volt vehicle battery.
Use another vehicle's 12 volt vehicle battery
to operate the vehicle
WARNING
Risk of injury! Danger of damage to vehicle!
▶
Lay the jump start cables so that they cannot be-
come caught by rotating parts in the engine com-
partment.
NOTICE
Short circuit!
▶
The non-insulated parts of the terminal clamps
must not touch each other.
▶
The cable connected to the positive pole of the 12
volt vehicle battery must not come into contact
with electrically conductive vehicle parts.
▶
The vehicles must not touch each other.
Connect the jump start cable
›
Switch o the ignition.
›
Connect the terminal clamps of the jump start ca-
bles in the order shown in the legend.
discharged 12 volt vehicle battery
current-supplying 12 volt vehicle battery
1
-pole of the discharged 12-volt vehicle battery
2
-pole of the current-supplying 12 volt vehicle
battery
3
-pole of the current-supplying 12 volt vehicle
battery (or earth point)
4
Earth point of the vehicle with discharged 12
volt vehicle battery
159
12 volt vehicle battery and fuses › Using the jump-starting cable
To Next Page
Loading...
Need help?
General
