Skoda Scala 2020 User Manual

Inate tyres
›
Fit the tyre ination hose of the air compressor to
the tyre valve.
›
Secure the vehicle with the parking brake.
›
Start the engine.
›
Plug the connector into the 12 volt socket .
›
Turn on the air compressor.
›
Once a tyre pressure of 2.0-2.5 bar is reached, turn
o the air compressor.
Observe the maximum running time of the air com-
pressor according to the directions of the repair kit
manufacturer.
›
If an air pressure of 2.0 - 2.5 bar has not been
reached, remove the tyre ination hose from the
valve.
›
Drive approx. 10 metres forwards or backwards to
allow the sealing agent to distribute in the tyre.
›
Replace the tire ination hose on the valve and re-
peat the ination procedure.
Tyre pressure
What you should be mindful of
NOTICE
▶
Always adjust the tyre pressure to the load.
▶
Check the pressure in all tyres at least once a
month and before each longer ride.
▶
Check the pressure when the tyres are cold. Do
not reduce the higher pressure of warm tyres.
▶
After each change in tyre pressure, save the new
values in the tyre control display.
WARNING
Risk of an accident!
▶
If tyre pressure loss is very quick, try to stop the
vehicle carefully without heavy steering or heavy
braking.
Sticker with prescribed tyre pressures
The sticker with prescribed tyre pressures is located
on the inside of the fuel ller ap.
A
Ination pressure for
half load
B
Ination pressure for
environmentally
friendly operation
(slightly lower fuel
consumption and
emissions)
C
Ination pressure for
a full load
D
Tyre diameter in in-
ches
This information only serves as information for
the prescribed tyre pressure. This is not a listing
of approved tyre sizes for your vehicle. These
are in the vehicle's technical documentation, as
well as in the declaration of conformity (in the
so-called COC document).
E
Tyre pressure reading for the front axle tyres
F
Tyre pressure reading for the rear axle tyres
G
Prescribed tyre pressure value for the emergen-
cy wheel
Tyre pressure monitor
Functionality
The tyre pressure monitoring indicator indicates a
change in tyre pressure.
Warning when pressure changes
illuminates
›
Stop the vehicle.
›
Check the tyres and tyre pressures.
Show tyres with modied pressure
›
In the following menu, select the menu item for
displaying the tyre condition:
Or:
Function restriction
The system is unable to provide a warning in the
event of a very rapid tyre pressure loss, e.g. sudden
puncture.
The system function may be restricted in the follow-
ing cases:
▶
Uneven loading of the wheels, e.g. with a trailer at-
tached
▶
Sporty driving style
▶
Driving on dirt roads
▶
Snow chains tted
Saving tyre pressure values
Store the tyre pressure values in the infotainment
›
Inate the tyres to the prescribed ination pres-
sure.
›
Turn on the ignition.
›
In the following menu, select the menu item for
displaying the vehicle condition:
Or:
168
Wheels › Tyre pressure

Skoda Scala 2020 Specifications

General

Brand	Skoda
Model	Scala 2020
Category	Automobile
Language	English