illuminates
›
Switch on the light.
Operation
Switching o the
lights except the
daytime running
lights
Switching the low
beam on/o auto-
matically
Switching on the
parking lights
Switching on the low
beam
As the basic position of the light switch, use posi-
tion .
High beam and headlight asher
The high beam works when the low beam is on.
A
Switch on high beam
B
Switch o main
beam / switch on
headlight asher
When the main beam or
headlight asher is
switched on, the indica-
tor lamp lights up in the instrument cluster .
CAUTION
Risk of an accident!
▶
Do not dazzle other road users with the high beam.
Turn signal
A
Switching on the
turn signal light on
the right - the warn-
ing light ashes in
the instrument clus-
ter
B
Switching on the
turn signal light on
the left - the warn-
ing light ashes in
the instrument clus-
ter
Turn signal - convenience signalling
Convenience signalling enables three ashes of the
turn signal lights without having to move the lever
up or down.
›
Tap the control lever up or down.
The corresponding turn signal lights ash three
times.
Tap the lever in the opposite direction ahead of
time to stop signalling.
Fog light
Positions for pulling out
the light switch
1
Fog lights - when
switched on, the in-
dicator light in the
instrument cluster il-
luminates
2
Rear fog light - when
switched on, the in-
dicator light in the
instrument cluster illuminates
›
Turn the light switch to position , or .
›
Pull the light switch to the appropriate position.
The rear fog light does not illuminate when an ac-
cessory is connected to the trailer socket.
Hazard warning light system
›
Press the button to switch on or o in the mid-
dle part of the control panel.
The hazard warning lights can be switched on auto-
matically during hard braking. The hazard warning
lights are then switched o again automatically
when starting o or accelerating.
When the hazard warning system is on and the
turn signal is switched on, the hazard warning lights
will be switched o temporarily and only the turn
signal will ash on the relevant side of the vehicle.
One-sided parking light
The one-sided parking light allows one side of the
parked vehicle to be illuminated through activation
of the corresponding sidelights.
A
Switch on the side-
lights on the right
B
Switch on the side-
lights on the left
›
Switch o the ignition.
›
Move the lever to the
appropriate position.
›
Lock the vehicle.
When the parking light is
switched on, an acoustic
warning signal sounds and the driver's door is
opened. After a few seconds or after the driver's
door is closed, the warning signal will stop.
Double-sided parking light
The two-sided parking light allows the parked vehi-
cle to be illuminated through activation of the side-
lights.
›
Turn on the ignition.
44
Lighting, windscreen wipers and washers › Exterior lighting
To Next Page
Loading...
Need help?
General
