Page 24 December 2007
Telescopic Boom Series
Models SJ61T & SJ66T
194312
Section 1 - Scheduled MaintenanceScheduled Maintenance Inspections
1.2 Function Tests
Function tests are designed to discover any malfunctions
before aerial platform is put into service. The operator
must understand and follow step-by-step instructions
to test all aerial platform functions.
IMPORTANT
Never use a malfunctioning aerial
platform. If malfunctions are discovered,
aerial platform must be tagged and
placed out of service. Repairs to aerial
platform may only be made by a qualied
service technician.
After repairs are completed, operator must perform a
pre-operation inspection and a series of function tests
again before putting aerial platform into service.
Prior to performing function tests, be sure to read
and understand “Section 3.8 - Start Operation" of the
operating manual.
For function test that are to be performed, please
refer to the operating manual that corresponds to the
correct serial number. Found there will be detailed
instructions for which tests to preform, as well as
how to properly and successfully perform them.
NOTE
All-function motion alarm should sound
while operating any boom and drive
function.
To Next Page
Loading...
Need help?
General
