Skyjack SJ82 T - Check the Oil Level in the Axle Gearbox; Change the Oil in the Axle Gearbox

252
SJ82 T, SJ86 T
229040ABA
Section 5 – Procedures Axles
5.9-4 Check the Oil Level in the Axle
Gearbox
1. Remove the fill plug
1
from the gear box.
2. Check the oil level. It should be even with the
bottom of the fill plug hole. Add oil if needed.
Refer to 2.10 Hydraulic Specifications & Gear Oil.
for oil specifications.
Fill
5.9-5 Change the Oil in the Axle Gearbox
1. Place a suitable container under the gearbox.
2. Remove the fill plug.
3. Remove the drain plug to allow oil to drain into
the container.
Fill
Drain
4. Reinstall the drain plug.
NOTE
The gearbox is full when oil is leaking from the
check port.
5. Refill the gearbox with new oil as per
specifications. Refer to 2.10 Hydraulic
Specifications & Gear Oil.
6. Reinstall the fill plug.
To order go to Discount-Equipment.com