257
Grease Points Section 5 – Procedures
5.10 Grease Points
Maintaining proper lubrication is essential for good performance and service life of the MEWP. If the
bearing and gear of the MEWP are improperly greased, it could result in component damage.
5.10-1 Grease the Turret Ring Gear
1. Open the control side cowling, and locate the turret ring gear grease fitting beside the hydraulic tank.
2. Pump grease into the fitting, and continue pumping until new lube appears continuously around the grease
seal lip of the ring gear.
3. Rotate the turret in increments of 4 to 5 inches (10 to 13 cm) at a time, and repeat step 2 until the entire
bearing has been greased.
5.10-2 Grease the Turret Swing Drive
1. Apply open gear lube to each tooth of the swing drive gear, located under the turret.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
