169
Deutz Diesel Engines Section 5 – Procedures
5.6 Deutz Diesel Engines
Maintaining the engine components is essential to the
good performance and service life of the MEWP.
5.6-1 Replace Engine Oil and Filter
Periodic replacement of the engine oil and filter is
essential to good engine performance.
NOTE
Warm the engine to normal operating temperature
before starting this procedure.
CAUTION
Beware of hot engine components and hot oil.
Contact with hot components may cause severe
burns.
1. Turn the engine off.
2. Remove the bolt securing the engine tray to the
turret.
3. Swing the engine tray away from the turret.
4. Place a suitable container under the engine oil
drain.
5. Remove the oil drain plug and allow all engine
oil to drain into the container.
WARNING
Dispose of oil in accordance with local and federal
regulations.
6. Install the oil drain plug with a new seal ring and
tighten firmly.
7. Remove the oil filter and catch any escaping oil.
8. Clean inside the filter head.
9. Add clean engine oil to the oil filter.
10. Apply a thin layer of engine oil to the new oil
filter gasket.
11. Install the filter and tighten it by hand.
12. Clean up any oil that may have spilled during
this procedure.
13. Refill the engine with new oil as per the
specifications (refer to the engine manual).
14. Swing the engine tray back to its original
position.
15. Reinstall the engine tray bolt.
16. Start the engine from the base control console
and allow the engine to run for 30 seconds, then
stop the engine.
17. Check for oil leakage.
18. Check the engine oil level on the dipstick and
add oil if needed.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
