192
Section 5 – Procedures Deutz Diesel Engines
Standstill Regeneration Stages
Standstill
Lamps
3 4
Engine
Lamp
5
Audible
Alarm
6
Engine
Torque
Action Required
Flashes slowly Off
Pulsates
slowly
100%
Perform the standstill operation at the next available
opportunity, within 3 to 4 hours.
Flashes slowly On
Pulsates
slowly
75%
The standstill operation must be performed
immediately.
Flashes quickly
Flashes
Pulsates
quickly
40%
a. The standstill operation is no longer possible with
on-machine controls.
Contact an authorized repair facility.
b. Failure to perform the standstill has resulted in
the diesel particulate filter failure, and regeneration
is no longer possible. Contact an authorized repair
facility to replace the filter.
Perform the Standstill Regeneration
1. Move the MEWP to an open, well-ventilated area,
away from any flammable material. Park it on a
firm level surface, and fully stow the MEWP.
2. With the engine running, turn the off/base/
platform switch
7
on the base controls to the
base position.
3. Activate the standstill regeneration by moving
the standstill switch
8
on the base controls to
the right. Base functions become inoperative
when the standstill switch is turned on.
4. On the engine display module
2
press and hold
the middle button
9
(below the regeneration
symbol) for 7 seconds.
WARNING
Do not touch hot engine components. Touching
hot surfaces may cause serious injury.
5. The engine display module changes to the
Regeneration Ongoing symbol
10
, the standstill
lamps turn solid, and the engine speed may
change.
6. Standstill regeneration takes approximately
45 minutes. During this time, the MEWP must
not be used.
IMPORTANT
The standstill regeneration must be completed
fully. If the process is interrupted, the standstill
request continues.
7. When the standstill regeneration is complete,
the Regeneration Ongoing symbol changes to
Regeneration Complete
11
, the standstill lamps
3 4
turn off, and the engine speed returns to
normal.
8. Move the standstill switch to the left. The MEWP
may now be used normally.
IMPORTANT
The derate override switch
12
on the front of the
platform control box should only be used when
absolutely necessary to move the MEWP to park it
in a safe location when the derated engine torque/
rpm prevents adequate torque to drive the MEWP.
It will temporarily (for approximately 30 minutes)
restore full engine power and speed.
Be aware that use of the derate override switch
may result in diesel particulate filter failure.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
