APPENDIX C
REMOTELY MANAGING THE DISPLAY
68 smarttech.com/kb/171257
NOTES
l Use ASCII formatted commands.
l Commands aren’t case-sensitive.
l When manually entering commands into a terminal emulation program, review each entry
carefully before you press ENTER to send a carriage return (0x0d) to terminate the
command.
l Don’t send another command until you receive the response and the next command
prompt.
To identify the current value of a setting
Use a get command.
This example shows how to get the display’s current volume setting:
>get volume
volume=55
>
To assign a value to a setting
Use a set command.
This example sets the volume to 65:
>set volume=65
volume=65
>
To Next Page
Loading...
