SMC Networks LECP1 Series User Manual

- 60 -
12.2 Alarm Content・Countermeasure
Group
The
condition of
the
controller
when an
alarm is
generated
How to
clear
the
alarm
Condition / Countermeasure
<Condition>
Problem occurred with the controller data or parameters.
B
Any
condition
Input
RESET
<Countermeasure>
If the problem is not solved by supplying power again, contact SMC.
<Condition>
During the pushing operation, the actuator is pushed back beyond the
start position of pushing.
C
During or
after
pushing
operation
Input
RESET
<Countermeasure>
Set a larger pushing thrust or reduce the reaction force of the load.
Refer to 8.3 Pushing operation (P.
40) for details of pushing
operation.
<Condition>
This is generated when return to origin, positioning, pushing or a jog
operation is commanded when the servo is OFF.
C Stopped
Input
RESET
<Countermeasure>
Check if I/O signal STOP is input. Also, check if the servo is OFF in
manual mode. Refer to 8.5 Servo ON (P.
43) for turning off the servo.
<Condition>
This is generated when positioning, pushing is commanded before
return to origin is completed.
C Stopped
Inpuｔ
RESET
<Countermeasure>
Start operation after the completion of the return to origin. Return to
origin must be performed after a group D alarm is generated and
deactivated.
<Condition>
Motor rotation exceeds specified value.
D
During
operation
Input
RESET
<Countermeasure>
If an external force is being applied, remove it. If there is no external
force being applied, and the problem is not solved by supplying power
again, please contact SMC.

SMC Networks LECP1 Series Specifications

General

Brand	SMC Networks
Model	LECP1 Series
Category	Controller
Language	English