C
ONFIGURING
THE
S
WITCH
2-98
IP address 192.168.1.1 and mask 255.255.255.255 — Specifies a valid IP
address of 192.168.1.1 only.
Note: IP filtering does not affect management access to the switch using
the Web interface or Telnet.
Command Attributes
• IP Filter List — Displays a list of the IP address/subnet mask entries
currently configured for SNMP access.
• IP address — Specifies a new IP address to add to the IP Filter List.
• Subnet Mask — Specifies a single IP address or group of addresses.
If the IP is the address of a single management station, the mask should
be set to 255.255.255.255. Otherwise, the IP address group is specified
by the mask.
Note: The default setting is null, which allows all IP groups SNMP access
to the switch. If one IP address is configured, the IP filtering is
enabled and only addresses in the IP group will have SNMP
access.
To Next Page
Loading...
