SMC Networks TigerSwitch 100 - Interface

I NTERFACE C OMMANDS
3-85
interface
Use this command to configure an interface type and enter interface
configuration mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-6)
• vlan vlan-id (Range: 1-4094)
Default Setting
None
Command Mode
Global Configuration
Example
To specify the Ethernet port, enter the following command:
port security Enables port security on an interface. IC 3-93
clear counters Clears statistics on an interface PE 3-94
show interfaces
status
Displays status for the specified interface NE,
PE
3-95
show interfaces
counters
Displays statistics for the specified interface NE,
PE
3-97
show interfaces
switchport
Displays the administrative and operational
status of an interface
NE,
PE
3-98
Command Function Mode Page