SNMP C
OMMANDS
3-61
Default Setting
None
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact (3-60)
snmp-server host
Use this command to specify the recipient of a Simple Network
Management Protocol notification operation. Use the no form to remove
the specified host.
Syntax
snmp-server host {host-addr community-string} [version 1 | 2c]
no snmp-server host host-addr
• host-addr - Name or Internet address of the host (the targeted
recipient). (Maximum host addresses: 5 trap destination IP address
entries)
• community-string - Password-like community string sent with the
notification operation. Though you can set this string using the
snmp-server host command by itself, we recommend you define
this string using the snmp-server community command prior to
using the snmp-server host command. (Maximum length:
32 characters)
• version - Specifies whether to send notifications as SNMP v1 or
SNMP v2c traps.
Console(config)#snmp-server location WC-19
Console(config)#
To Next Page
Loading...
