VLAN C
OMMANDS
3-123
vlan
Use this command to configure a VLAN. Use the no form to restore the
default settings or delete a VLAN.
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active |
suspend}]
no vlan vlan-id [name | state]
• vlan-id - ID of configured VLAN. (Range: 1-4094, no leading zeroes)
• name - Keyword to be followed by the VLAN name.
• vlan-name - ASCII string from 1 to 32 characters.
• media ethernet - Ethernet media type.
• state - Keyword to be followed by the VLAN state.
- active - VLAN is operational.
- suspend - VLAN is suspended. Suspended VLANs do not
pass packets.
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
• When no vlan vlan-id is used, the VLAN is deleted.
• When no vlan vlan-id name is used, the VLAN name is removed.
• When no vlan vlan-id state is used, the VLAN returns to the default
state (i.e., active).
• VLAN 1 cannot be suspended, but any other VLAN can be suspended.
• You can configure up to 255 VLANs on the switch.
To Next Page
Loading...
