SMC Networks TigerSwitch 100 - Map Ip Precedence (Interface Configuration)

P RIORITY C OMMANDS
3-157
Example
The following example shows how to enable IP precedence mapping
globally:
map ip precedence (Interface Configuration)
Use this command to set IP precedence priority (i.e., IP Type of Service
priority). Use the no form to restore the default table.
Syntax
map ip precedence ip-precedence-value cos cos-value
no map ip precedence
• precedence-value - 3-bit precedence value. (Range: 0-7)
• cos-value - Class-of-Service value (Range: 0-7)
Default Setting
The list below shows the default priority mapping.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#map ip precedence
Console(config)#
IP Precedence Value CoS Value
00
11
22
33
44
55
66
77