C
OMMAND
L
INE
I
NTERFACE
3-14
Command Usage
The “>” character is appended to the end of the prompt to indicate
that the system is in normal access mode.
Example
Related Commands
enable (3-12)
configure
Use this command to activate Global Configuration mode. You must enter
this mode to modify any settings on the switch. You must also enter
Global Configuration mode prior to enabling some of the other
configuration modes, including Interface Configuration, Line
Configuration, and VLAN Database Configuration. See “Understanding
Command Modes” on page 3-6.
Default Setting
None
Command Mode
Privileged Exec
Example
Related Commands
end (3-16)
Console#disable
Console>
Console#configure
Console(config)#
To Next Page
Loading...
