C
OMMAND
L
INE
I
NTERFACE
3-44
Default Setting
None
Command Mode
Privileged Exec
Example
show startup-config
Use this command to display the configuration file stored in nonvolatile
memory that is used to start up the system.
Default Setting
None
Console#show logging flash
Syslog logging: Disable
History logging in FLASH: level errors
Console#show logging trap
Syslog logging: Enable
REMOTELOG status: enable
REMOTELOG facility type: local use 3
REMOTELOG level type: Warning conditions
REMOTELOG server ip address: 10.1.0.3
REMOTELOG server ip address: 10.1.0.4
REMOTELOG server ip address: 0.0.0.0
REMOTELOG server ip address: 0.0.0.0
REMOTELOG server ip address: 0.0.0.0
Console#show logging ram
Syslog logging: Enable
History logging in RAM: level debugging
[3] 0:0:41 1/1/1
"VLAN 1 link-up notification."
level: 6, module: 6, function: 1, and event no.: 1
[2] 0:0:41 1/1/1
"STP topology change notification."
level: 6, module: 6, function: 1, and event no.: 1
[1] 0:0:12 1/1/1
"Unit 1, Port 5 link-up notification."
level: 6, module: 6, function: 1, and event no.: 1
[0] 0:0:11 1/1/1
"System coldStart notification."
level: 6, module: 6, function: 1, and event no.: 1
Console#
To Next Page
Loading...
