C
OMMAND
L
INE
I
NTERFACE
3-70
ip default-gateway
Use this command to a establish a static route between this device and
management stations that exist on another network segment. Use the no
form to remove the static route.
Syntax
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Command Usage
A gateway must be defined if the management station is located in a
different IP segment.
Example
The following example defines a default gateway for this device:
Related Commands
show ip redirects (3-71)
show ip interface
Use this command to display the settings of an IP interface.
Default Setting
All interfaces
Console(config)#ip default-gateway 10.1.0.254
Console(config)#
To Next Page
Loading...
