SMC Networks TigerSwitch 100 - Stopbits; Show Line

L INE C OMMANDS
3-83
stopbits
Use this command to set the number of the stop bits transmitted per byte.
Use the no form to restore the default setting.
Syntax
stopbits {1 | 2}
• 1 - One stop bit
• 2 - Two stop bits
Default Setting
1 stop bit
Command Mode
Line Configuration
Example
To specify 2 stop bits, enter this command:
show line
Use this command to display the terminal line's parameters.
Syntax
show line [console | vty]
• console - Console terminal line.
• vty - Virtual terminal for remote console access.
Default Setting
Shows all lines
Console(config-line)#speed 57600
Console(config-line)#
Console(config-line)#stopbits 2
Console(config-line)#