C
OMMAND
L
INE
I
NTERFACE
3-10
Command Groups
The system commands can be broken down into the functional groups
shown below
.
Command
Group
Description Page
General Basic commands for entering privileged access mode,
restarting the system, or quitting the CLI
3-12
Flash/File Manages code image or switch configuration files 3-18
System
Management
Controls system logs, system passwords, user name,
jumbo frame support, browser management options,
HTTPS, SSH, and a variety of other system
information
3-25
Authentication Configures RADIUS and TACACS+ client-server
authentication for logon access
3-50
SNMP Activates authentication failure traps; configures
community access strings, and trap managers
3-58
IP Configures the IP address and gateway for
management access, displays the default gateway, or
pings a specified device
3-67
Line Sets communication parameters for the serial port,
including baud rate and console time-out.
3-73
Interface Configures the connection parameters for all
Ethernet ports, aggregated links, and VLANs
3-84
Address Table Configures the address table for filtering specified
addresses, displaying current entries, clearing the
table, or setting the aging time
3-100
Spanning Tree Configures Spanning Tree settings for the switch 3-105
VLAN Configures VLAN settings, and defines port
membership for VLAN groups
3-121
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for bridge
extension MIB
3-132
To Next Page
Loading...
