SMC Networks TigerSwitch 100 - Databits

C OMMAND L INE I NTERFACE
3-80
Default Setting
The default value is no silent-time.
Command Mode
Line Configuration
Command Usage
If the password threshold was not set with the password-thresh
command, silent-time begins after the default value of three failed
logon attempts.
Example
To set the silent time to 60 seconds, enter this command:
Related Commands
password-thresh (3-78)
databits
Use this command to set the number of data bits per character that are
interpreted and generated by the console port. Use the no form to restore
the default value.
Syntax
databits {7 | 8}
no databits
• 7 - Seven data bits per character.
• 8 - Eight data bits per character.
Default Setting
8 data bits per character
Console(config-line)#silent-time 60
Console(config-line)#