C
OMMAND
L
INE
I
NTERFACE
3-26
show ip ssh Displays the status of the SSH server and the
configured values for authentication timeout
and retries
PE
3-37
show ssh Displays the status of current SSH sessions
PE
3-37
Event Logging Commands
logging on Controls logging of error messages GC 3-38
logging history Limits syslog messages sent to the SNMP
network management station based on
severity
GC 3-39
logging host Adds a syslog server host IP address that will
receive logging messages
GC 3-40
logging facility Sets the facility type for remote logging of
syslog messages
GC 3-41
logging trap Limits syslog messages saved to a remote
server based on severity
GC 3-42
clear logging Clears messages from the logging buffer PE 3-43
show logging Displays the state of logging PE 3-43
System Status Commands
show
startup-config
Displays the contents of the configuration file
(stored in Flash memory) that is used to start
up the system
PE 3-44
show
running-config
Displays the configuration data currently in
use
PE 3-46
show system Displays system information NE,
PE
3-47
show users Shows all active console and Telnet sessions,
including user name, idle time, and IP address
of Telnet client
NE,
PE
3-48
show version Displays version information for the system NE,
PE
3-49
Command Function Mode Page
To Next Page
Loading...
