Snap-On PRO-LINK EDGE - Logout Repair-Connect

- Features Available from the Drop-Down Menu
PRO-LINK
®
Edge Hardware and Software User’s Manual 107
Logout Repair-Connect
Once you have logged in to Repair-Connect, PRO-LINK
®
Edge remembers your
login credentials so you don’t have to enter them again. Then, you are automati-
cally logged when you access detailed information for a fault during your active
diagnostic session.This is why the Logout Repair-Connect feature is only avail-
able once you have logged into Repair-Connect for the current session.
NOTE:
i For detailed information on using Repair-Connect, see Chapter 10: Using
PRO-LINK
®
Repair-Connect, later in this manual.
To log out of Repair-Connect:
1 Touch drop-down menu located in the upper-left corner of the display.
Figure 4.55 Drop-down Menu Showing Logout Repair-Connect
2 Touch Logout Repair-Connect.
A “Logging out of PRO-LINK
®
Repair-Connect” message is displayed.