Snap-On PRO-LINK EDGE - Changing Wireless Settings

134 PRO-LINK
®
Edge Hardware and Software User’s Manual
Chapter 6 • Using the Settings Menu
Changing Wireless Settings
You use the Configure Wireless Adapter screen if you want to change what type
of IP address your PRO-LINK
®
Edge will have:
• Dynamic IP address (automatically selected and variable)
• Static IP address (you assign an address that does not change)
NOTE:
i For a dynamic IP address, you don’t need to change the settings; the
default is Automatically. However, you can change the DNS settings in
either automatic or manual mode.
To assign a static IP address:
1 Select Change Wireless Settings from the Network Settings screen
(Figure 6.3).
Figure 6.6 Configure Wireless Adapter
2 Select Manually.
NOTE:
i You will need to obtain this information (i.e., IP Address, Subnet Mask)
from the designated IT person or network administrator for your location.
You may also need to enter Gateway and DNS information.