- Introduction to Tab Functions
PRO-LINK
®
Edge Hardware and Software User’s Manual 49
The Tests Tab
The Tests tab is used to perform special tests. Some of the tests you can run
include the following:
•Histograms
• Injector actuation pressure tests
• Injector solenoid tests
A typical test enables you to perform a function or test to aid in the diagnostics of
a vehicle or system. For example, the Cylinder Cutout Test enables you to turn
on or turn off the cylinders in an engine to help diagnose problems with an individ-
ual cylinder or group of cylinders.
The PRO-LINK
®
Edge enables you to perform the special tests that have been
programmed into the ECM by the original equipment manufacturer (OEM).
When you select the Tests tab, the Module Selection screen is displayed.
Depending on the vehicle you are connected to, there may be multiple modules to
choose from.
Figure 3.20 Module Selection Screen
To Next Page
Loading...
