Snap-On PRO-LINK EDGE - Introduction to Tab Functions; The Faults Tab

- Introduction to Tab Functions
PRO-LINK
®
Edge Hardware and Software User’s Manual 41
Introduction to Tab Functions
Once the PRO-LINK
®
Edge has scanned the vehicle for faults, the Diagnostics
Menu is displayed (Figure 3.12). A number of menu-selection tabs are displayed
on the left side of the screen.
•Faults (pg. 41)
• Parameters (pg. 42)
• Calibrations (pg. 44)
•Tests (pg. 49)
The following subsections briefly introduce each of the tabs of the Diagnostics
Menu.
NOTE:
i For detailed instructions on using each of the tabs on the Diagnostics
Menu, see Chapter 4: Using the Diagnostics Menu, later in this manual.
The Faults Tab
The Faults tab displays the faults detected on the vehicle for all modules. The
faults are separated into two lists, ACTIVE FAULTS and INACTIVE FAULTS.
Figure 3.12 Active and Inactive Fault Codes