Snap-On PRO-LINK EDGE - Clearing Inactive Faults

62 PRO-LINK
®
Edge Hardware and Software User’s Manual
Chapter 4 • Using the Diagnostics Menu
Clearing Inactive Faults
Inactive faults can be cleared by touching the Clear All Faults button at the bottom
of the screen. Faults may not be cleared individually.
NOTE:
i When you clear all faults, both ACTIVE and INACTIVE faults are cleared.
Then the PRO-LINK
®
Edge re-scans the vehicle and re-lists the ACTIVE
faults found during the re-scan.
To clear all inactive faults:
Figure 4.4 Sample Faults Screen
1 Touch Clear All Faults.
An “Are you sure you want to clear all faults?” question box is displayed.
2 To confirm your decision to clear all faults, touch Ye
s.
All faults are cleared, the vehicle is re-sca
nned, and any faults that are still
active will be re-displayed.