Snap-On PRO-LINK EDGE - Page 134

- The Settings Menu
PRO-LINK
®
Edge Hardware and Software User’s Manual 131
To connect to a wireless network:
1 Touch the screen to highlight the network in the list you wish to connect to
(e.g., SBSPublic).
NOTE:
i If the network you want to connect to does not appear in the list, you can
add it. Touch the Add Wireless Network link near the bottom of the
screen and follow the prompts.
2 Touch the Connect button.
The Add Wireless Network screen is displayed.
3 Touch Conne
ct after entering the required information (e.g., a password if
required.
The screen is refreshed and the status is updated to “Connected.”
Figure 6.4 Wireless Status: Connected
NOTE:
i To modify network settings, select the network and touch the Modify but-
ton. To disconnect from the wireless ne
twork to which you are currently
connected, select the network and touch the Forget button.