socomec ISOM Digiware - Status Indicators and Addressing; Status LEDs and Buttons; ISOM Digiware L-60 LEDs and Buttons

51EN
ISOM DIGIWARE - 546780C - SOCOMEC
8. STATUS LEDS, BUTTONS AND AUTO-ADDRESSING
8.1. Status LEDs and buttons
These LEDs can be used to nd out the status of the product at any time. Use specic buttons to go straight to the
devices' main functions.
8.1.1. L-60
ON
INJ
FAULT
ALARM 1
RESET
TEST
INJ
START/STOP
ALARM 2
COM
FE
14 11 12
1
C
Output
C
Input
234
2224 21
Alarm2Alarm1
L1 L2
DIGIWARE BUS
θ >
L-60tISOM
KE
Power supply (green)
Insulation alert ALARM1
Insulation alert ALARM2
Manual RESET button
Manual test button
(TEST)
Status LED for FLD booster (INJ)
Manual boost START/
STOP button: this button
is mainly used in the
portable locating phase.
It is prioritised in Settings
mode (see § 10.1.2)
System fault (red)
Communication (amber)
Addressing button
LED state Fixed Blinking Pulse
ON
In operation The screen communicates with
the device to retrieve the values/
data to display.
10 seconds – on request by
a Modbus control command
to identify the device (remote
screen…)
1 second to start-up
FAULT
An alarm (logical/analogue) is
active (does not take priority if
there is a setup alarm at the same
time)
At least one startup alarm is
active.
1 second to start-up
COM
Addressing problem. Address OK 1 second to start-up and when a
frame received is processed
ALARM 1
Alarm sent when lowest threshold
is not met – ALARM1
ALARM 2
Alarm sent when lowest threshold
is not met – ALARM2
INJ
Injection in fault-locating mode
is ON
When the device is in manual test
mode