socomec ISOM Digiware - System Configuration; Configuration Using Easy Config Software; Easy Config Connection Modes

56 EN
ISOM DIGIWARE - 546780C - SOCOMEC
10. CONFIGURATION
Conguration can be carried out using the EasyCong conguration software or directly from the remote display. The
Easy Cong software is used to congure ISOM Digiware directly via RS485 or USB. Easy Cong must be installed
before using the USB connection. To set the parameters from the remote display D-75 or D-55, refer to the manual
for the display.
10.1. Conguration using Easy Cong
10.1.1. Connection modes
Conguration using Easy Cong (USB)
Easy Cong
Supervision
MODBUS TCP
USB
ISOM F-60
Conguration using Easy Cong via a display
Supervision
MODBUS TCP
Easy Cong
ISOM Digiware D-55 / D-75
USB