socomec ISOM Digiware - Setting Up Alarms; ALARM LED Indicator; Alarm Output Activation; Alarm Acknowledgment via Input

71EN
ISOM DIGIWARE - 546780C - SOCOMEC
• Voltage network outside specied range (L-60)
The voltage network connected is outside the working range.
• Device temperature too high (L-60)
The device is overheating (automatically stop the LCI booster)
• Loss of communication (L-60)
The device is no longer connected to a master of the Digiware bus
• Level outside of the operating range (L-60)
IMD measurement is outside the tolerance range and cannot be shown, the L60 is blind
• Core balance transformer disconnected (F-60)
Alarm for detecting the absence of a current sensor
• VI link alarm (F-60)
Alarm for connection error between the current and the voltage
Requires a specic load level: 0.6 < PF < 1 and I> 2% In
• Alert for bad primary TC (F-60)
Conguration error in the primary circuit of the core balance transformer.
11.2. Setting up alarms
The installation alarms are automatically detected and alarms upon events are congured with the Easy Cong
software.
There are several ways of identifying the presence of an alarm:
11.2.1. ALARM LED on front
• Flashing: Setup alarm
• Constant: Alarm for an event (takes priority if there is a setup alarm at the same time)
11.2.2. Activation of an output
• On ISOM Digiware L-60 and t F-60, one or more outputs can be activated when an alarm is detected
11.2.3. Acknowledging alarms by input
• If an input is present, the alarm can be acknowledged from this input. Acknowledgement of an alarm can only be
taken into account if the alarm is complete
11.2.4. RS485 Modbus
• Information on the alarms with timestamping available via the RS485 communication bus
• Sends alarm acknowledgement
11.2.5. Display and WEBVIEW
• Information on alarms with timestamping
• Sends alarm acknowledgement