socomec ISOM Digiware - Using the Easy Config Software

57EN
ISOM DIGIWARE - 546780C - SOCOMEC
Conguration using Easy Cong via an ISOM Digiware D-55 / D-75 display (Ethernet)
Supervision
MODBUS TCP
Web server
WEBVIEW (ISOM Digiware D-75)
ISOM Digiware D-55 / D-75
These products must be connected to the power supply before you congure them.
For the Digiware bus and 120-ohm termination resistors, see "Communication" on page “9.
COMMUNICATION”, page 54.
10.1.2. Using Easy Cong
Easy Cong is conguration software used to set product parameters easily and quickly. Settings are made in
sequence:
Device —> Network —> Insulation —> Measurement method —> Values to be stored —> Alarms —> End of
conguration
Other steps may appear, depending on the version of your device (example: Loads or Inputs/Outputs)