SolarEdge StorEdge SE7600A-USS - System Activation, Pairing, and Verification

Chapter 6: Commissioning the Installation
Thischapterdescribeshowtoactivatethesystem,pairthepoweroptimizerstotheinverterandverify
theproperfunctioningofthesystem.
Removing the Inverter Cover
Iftheinvertercoverisnotalreadyremoved,usethefollowingprocedureforcoverremovalfor
communicationconnectionormaintenancepurposes.
1. TurntheStorEdgeConnectionUnittoOFF.
2. TurntheinverterON/OFFswitchtoOFF.
3. DisconnecttheACtotheinverterbyturningOFFthecircuitbreakersonthedistributionpanel.Wait
5minutesforthecapacitorstodischarge.
4. Opentheinvertercover’ssixAllenscrewsandcarefullypullthecoverhorizontallybeforeloweringit.
CAUTION!
When removing the cover, make sure not to damage internal components. SolarEdge will not be held
responsible for any components damaged as a result of incautious cover removal.
Lors du retrait du couvercle, assurez-vous de ne pas endommager les composants internes. SolarEdge
ne peut être tenue pour responsable des composants endommagés à la suite d'une imprudence dans le
retrait du couvercle.
SolarEdge StorEdge Installation Guide MAN-01-000262-1.2
44
Chapter 6: Commissioning the Installation