45
2-3-3. VIO-38 Board
Preparation
1. Remove the bottom harness guard. (Refer to “2-2. Bottom Harness Guard”.)
2. Remove the outside panel assembly. (Refer to “2-3. Outside Panel Assembly”.)
3. Remove the XLR assembly. (Refer to “2-3-2. AXM-62 Board”.)
Procedure
1. Disconnect the flexible flat cable from the connector (CN202) on the VIO-38 board.
2. Remove the precision screw, and then remove the VIO-38 board.
3. Disconnect the flexible board from the connector (CN101) on the VIO-38 board.
4. Install the removed parts by reversing the steps of removal.
Precision screw
(P2 x 4)
VIO-38 board
CN202
Flexible board
Hole
Hole
CN101
Bosses
Flexible flat cable
To Next Page
Loading...