71
2-9-2. EC-94 Board
Preparation
1. Remove the bottom harness guard. (Refer to “2-2. Bottom Harness Guard”.)
2. Remove the inside panel assembly. (Refer to “2-4. Inside Panel Assembly”.)
3. Remove the DC fan. (Refer to “2-8. DC Fan”.)
4. Remove the media assembly. (Refer to “2-9. Media Assembly”.)
5. Remove the SD-74 board assembly. (Refer to “2-9-1. SD-74 Board Assembly”.)
Procedure
1. Release the flexible flat cable from the two hooks.
2. Disconnect the flexible flat cable from the connector (CN002) on the EC-94 board.
Note
At the time of the installation, clamp the flexible flat cable with the two hooks.
3. Remove the two precision screws, and then remove the EC-94 board.
Flexible flat cable
Flexible flat cable
EC-94 board
CN002
Hooks
Hooks
EC-94 board assembly
Hole
Precision screws
(PTP2 x 5)
Hole
Bosses
To Next Page
Loading...